EDITOR BOARD MEMBERS :  VIEW ALL

Dr Bikasih Thapa & Dr Maheswar Prasad (Nepal) - Hideo Wada MD PhD (japan) - Dr a Lavra Castrocatesana (Mexico) - Dr Mrs N.M. Hettiarachechui (Srilanka) - Dr Jorge Aldrete Velasco (Mexico) - Prof Hans Peter Kohler (Switzerland) - Dr Hermanus Suhartono S Sp.OG(K) PhD - Dr Isabel Pinheiro (Portugal) - Dr Suranga (Srilanka) - Jovia Dino Jansen Amsterdam,Holand - Hideo Wada MD PhD University Graduate School of Medicine Departement of Moleculer and Laboratory Medicine Japan - DR Bikash Thapa Internal Medicine Nepal University - DR Maheswar Prasad Internal Medicine Nepal University - Dr a Lavra Castro Castresana Colegio de Medicina interna de Mexico - Dr Suransa Manilgama University of Srilanka Internal Departement Medicine - Dr Mrs N.M. Hettiarachechui University of Medicine Srilanka - Dr Jorge Aldrete Velaso .Colegio de Medicina Interna de Mexico - Prof Hans Peter Kholer M.D FACD Profesor of Medicine University ot Switzerland - Dr Ramezan Ali Atace . Baqiyatallah University of Medical Sciences Departement of Micrology Tehran Iran - Ezekiel Wong Toh Yoon Dr. Gastroenterology of Japan - D Eric Beck,MD Bethesda Hospital Capitol Boelevard St Paul USA - Dr Emine Guderen Sahin Istambul University of Internal Medicine Turky - Dr Selmin Toplan Istambul University - Dr Nicholas New Australia - Dr Kughan Govinden. Tropical Infection of Internal Medicine Malaysia - Dr Godfrey M Rwegerera Princes Marina Hospital Bostwana -

Title : EXPERIMENTAL INVESTIGATION TO OPTIMIZE THE PROCESS PARAMETERS IN DRILLING OPERATION FOR COMPOSITE MATERIALS

Author : VARDIREDDY VISWESWARA REDDY, MOHARLA ADINARAYANA RAJU, Dr T. SURYA SEKHARA REDDY

Abstract :

With the use of 8mm, 10mm, and 12mm diameter HSS (M2) drills, spindle speeds of 1200, 1000, and 800 rpm, and feeds of 30, 40, and 50 mm/min, this study will perform tests to enhance the surface finish quality of GFRP (glass fibre reinforced polymer) composites work pieces. The Taguchi technique is a powerful tool for studying the impact of process parameters and finding the relationship between surface finish—the most important machinability factor— and cutting speed, feed, and depth of cut. The experimental results and the validated model equations are found to agree quite well.

[ PDF ]

Editor Board
Editor in chief

Dr. Arend L Mapanawang, Sp.PD, FINASIM, PhD

Subject Area

Every article submitted to IJHMCR is screened by Turnitin software.

Indexing

PENGUNJUNG KAMI DARI BERBAGAI BELAHAN DUNIA